Miele PWM 511 Operating And Installation Instructions page 40

Problem solving guide
Problem
The following appears in
F -Door lock
the display:
fault. You can continue by
pressing the "Start/Stop"
button.
The display is dark and the
Start/Stop sensor is
flashing slowly.
The programme is in the
pre-start screen and the
Start/Stop sensor flashes.
40
Possible cause and remedy
The door is not locked properly. The door lock could not
engage.
Close the door again.

Start the programme again.

If the fault message appears again, contact Miele.
The display has switched off automatically to save energy.
Touch any sensor. The display will switch on again.

The drum door is only ajar, but not correctly closed.
Check whether the drum door is closed correctly.
