Technical Safety - Miele PWM 909 SOM Quick Start Manual

Commercial washing machine
Hide thumbs Also See for PWM 909 SOM:
Table of Contents

Advertisement

Available languages

Available languages

en - Warnings and safety notes
54

Technical safety

Before setting up the washing machine, check it for any externally
visible damage. Do not install or use a damaged washing machine.
The electrical safety of this washing machine can only be guaran-
teed when correctly earthed. It is most important that this basic
safety requirement is tested and in case of any doubt the on-site wir-
ing system should be inspected by a specialist. Miele cannot be held
liable for the consequences of an inadequate earthing system.
Unauthorised repairs could result in unforeseen dangers for the
user, for which the manufacturer cannot accept liability. Repairs
should only be undertaken by a Miele authorised technician, other-
wise any subsequent damage will not be covered by the warranty.
Do not make any alterations to the washing machine, unless au-
thorised to do so by Miele.
Disconnect the washing machine from the power supply in the
event of a fault and for cleaning and maintenance. The washing ma-
chine is only electrically disconnected from the power supply when:
- the plug of the washing machine is unplugged, or
- the mains fuse is disconnected, or
- the screw-in fuse has been completely removed
For more information, see "Installation – Electrical connection".
The washing machine may only be connected to the water supply
using the set of hoses supplied with the machine. Old sets of hoses
must not be re-used. Check the sets of hoses regularly for signs of
wear. Change the sets of hoses in good time to avoid the risk of leaks
and subsequent water damage.
The cause of any leaks must be dealt with before the washing ma-
chine is restarted. Disconnect the washing machine immediately if
any water leaks out.
Faulty components must only be replaced by genuine Miele spare
parts. Miele can only guarantee the safety standards of the machine
when Miele spare parts are used.
All relevant national provisions and regulations (DGUV in Germany)
relating to accident insurance are applicable to this machine. It is re-
commended to carry out testing in accordance with the regulatory
framework described in DGUV 100-500/Chapter 2.6/Section 4. The
test book required for the documentation is available from the Miele
Customer Service Department.
Please observe the instructions in "Installation and connection"
and "Technical data".
The plug for the washing machine must always be kept accessible
so that the machine can be easily disconnected from the power sup-
ply.

Advertisement

Table of Contents
loading

Table of Contents