Table of Contents
Advertisement
5.1.13 Conduct 3D Positioning
3D positioning is to relocate the selected area to the image center.
Steps
1. Click
to enable the function.
2. Select a target area in live image.
- Left click on a point on live image: the point is relocated to the center of the live image. With
no zooming in or out effect.
- Hold and drag the mouse to a lower right position to frame an area on the live: the framed
area is zoomed in and relocated to the center of the live image.
- Hold and drag the mouse to an upper left position to frame an area on the live: the framed
area is zoomed out and relocated to the center of the live image.
3. Click the button again to turn off the function.
5.1.14 OSD Menu
When network access is unavailable, you can call the Preset No.95 to show OSD menu to start
device configuration.
Click direction buttons or
Click
to confirm your selection.
5.1.15 Display Target Information on Live View
Go to Configuration → Local → Live View Parameters for settings.
Note
Related smart function should be configured and enabled in advance.
Display POS Information
POS information refers to the target features, such as target ID, etc. Supported POS information
types varies according to device models.
5.2 Set Transmission Parameters
The live view image may be displayed abnormally according to the network conditions. In different
network environments, you can adjust the transmission parameters to solve the problem.
Steps
1. Go to Configuration → Local .
2. Set the transmission parameters as required.
TandemVu PTZ Camera User Manual
and
to move up and down.
37
Advertisement
Table of Contents
