Assembly Instructions - Kärcher G 4000 OH servo press Manual

■ Do not leave machine running unattended.
■ Avoid tipping machine on its side.
SAVE THESE INSTRUCTIONS
CAUTION
When connecting to water supply mains,
local regulations of your municipal water
company must be observed. In some
areas connecting directly to public drink-
ing water supply may require a backfl ow
prevention device. This is to ensure that
there is no feedback of chemicals into the
water supply. Use a water fi lter to avoid
potential damage from dirt in the water
supply.
■ Garden hose must be at least 5/8 inch
diameter.
■ Flow rate of water supply must not fall
below 4.0 GPM (gallons per minute)
Description
Knob
A
5/16" X 1 3/4
B
Bolt
5/16" X 2" Bolt
C
D Hose Holder
E High Pressure
Hose
IMPORTANT SAFETY INSTRUCTIONS
WATER SUPPLY (Cold Water Only)

ASSEMBLY INSTRUCTIONS

Hardware (included)
Purpose
Joint Assembly
Joint Assembly
Hose Holder Assembly
Hose Holder Assembly
Spray Gun Assembly
Unloader Valve
DO NOT ADJUST. The Unloader Valve con-
trols water fl ow through the pump and is preset
at the factory. Further adjustments may cause
damage to the pump and void the warranty.
■ Flow rate can be determined by running
the water for one minute into an empty
5-gallon container.
■ The water supply temperature must not
exceed 122°F/50°C.
■ Never use the pressure washer to draw
in water contaminated with solvents, e.g.
paint thinners, gasoline, oil, etc.
■ Always prevent debris from being drawn
into the unit by using a clean water source.
Use additional water fi lter.
■ Do not operate pressure washer without
the water turned on.
Illustration Qty
2
2
1
1
1
English 5