Shutting Down & Clean-Up; Winterizing And Long-Term Storage; Maintenance Instructions - Kärcher G 4000 OH servo press Manual

STEP 1:
If detergents have been used, remove
detergent suction tube from container and
insert into 1 gallon of fresh water.
Siphon water at low pressure for one
minute to clear the line of residual deter-
gent.
STEP 2:
Move the engine stop switch to the OFF
position. Close the fuel valve.
STEP 3:
Turn off the water source.
STEP 4:
Press trigger to release water pressure.
1: Disconnect all water connections.
2: Turn on the machine for a few seconds,
until the water which had remained in the
pump exits, turn off immediately.
3: Do not allow high pressure hose to
become kinked.
4: Store the machine and accessories
in a room which does not reach freezing
temperatures. DO NOT store near furnace
or other sources of heat as it may dry the
pump seals.
Kärcher pump
Initial Use
All Kärcher pumps ship with oil already inside
direct from the factory. There is no need to
add oil.
Pump Inspection
You should routinely make a visual inspec-
tion of the pressure washer's pump. If you
notice oil leaking around the pump seals, you
should take the pressure washer to a Kärcher-
Authorized Service Center for repair. (You can
locate a service center in your area online at:
www.karcher-service.com).
10 English
SHUTTING DOWN & CLEAN-UP

WINTERIZING AND LONG-TERM STORAGE

MAINTENANCE INSTRUCTIONS

STEP 5:
Release trigger and engage gun safety
lock.
STEP 6:
Disconnect the garden hose from the water
inlet on the unit.
STEP 7:
Disconnect the high pressure hose from
the high pressure outlet. Store the high
pressure hose in the hose holder assem-
bly.
CAUTION
Failure to follow the above directions will
result in damage to the pump assembly
and accessories and will void the warranty.
It is highly recommended to use Kärcher's
Pump Guard (part number 9.558-998.0)
before winter storage and during the
cleaning season to protect the pump from
freezing and premature wear.
Pump Maintenance
The pump on your Kärcher pressure washer
does not require maintenance. Any attempts
to service or alter the pump may damage
your pressure washer and void your product
warranty.
Engine
Carry out maintenance tasks for the engine
according to the specifi cations provided in
the operating instructions provided by engine
manufacturer.