Finding The Tv's Video Line Input - RCA VRM420 User Manual

TV Button
ON•OFF
REVERSE
RECORD
INFO
MUTE
CLEAR
1
2
4 5
7 8
0
TRACKING
INPUT
Button
Chapter 5
TV VCR
PLAY FORWARD
STOP PAUSE
SEARCH
GO BACK
MENU SPEED
3
6
9
F.ADV
Other Information

Finding the TV's Video Line Input

You need to tune your TV to the video line input if you are using
the VCR's Audio/Video (A/V) OUT jacks to connect to the TV's A/
V input jacks. You must select the TV's video line input before you
can see the VCR's menus, the cable/antenna reception, and the
content that's on a tape.
The video line input for TVs varies by brand and model. Below
are some steps to try to find your TV's video line input:
• If your TV brand is RCA, GE, or Proscan, press the TV button on the
VCR's remote control, then press the INPUT button.
• If you have another brand of TV, see the chapter Using the Remote
Control to see if the VCR's remote can be programmed to control
your TV. If so, once completed, follow the step above.
If those options do not work, try the following ideas. You might
access the video line input by:
• Pressing a button on the TV's remote control (see the table below).
• Selecting a specific channel from the TV's on-screen menu system
(see the table below).
• Tuning directly to the video line input by selecting a specific channel
number (see the table below)
• Going through all available channels by pressing the channel up or
down buttons on the TV or its remote control.
Common Video Line Input scenarios:
Video Input Channel Variations
Button/Switch
on the TV
VIDEO
SIGNAL
VID 1
VID 2
S-VID
S-VIDEO
Button on the Channel
TV Remote Number
VID 1 00
LINE 90
VID 91
VIDEO 92
S-VID 93
INPUT VID 1
S-VIDEO VID 2
SOURCE
AUX
47