Table of Contents
Advertisement
AUTO REPEAT
Set the length of time
you want the tape to
play in a repeating loop
Loop from 0:00 to 2:--
Press CLEAR to turn off
Press MENU to exit
Chapter 2
Set Auto Repeat
A tape can be set to play the same segment over and over in a repeating
loop with the Set Auto Repeat feature. Set Auto Repeat uses the VCR's
memory counter to determine the duration of the loop.
In the PREFERENCES menu, press the 7 button to choose Set Auto
(h:mm)
Repeat. The Set Auto Repeat menu will ask for a loop end time to be
specified:
•
The CLEAR button will erase all three numbers entered and move the cursor
back to the first position (hours).
•
The Press CLEAR to turn off message will appear only after the first number
has been entered into the end time.
•
Auto Repeat is set back to -:-- by resetting the dialog box, ejecting a tape,
powering off the VCR, power interruption, or by recording start.
When a duration time has been set:
•
The VCR will automatically switch to rewind if the counter meets or goes
past the set Auto Repeat duration.
•
The VCR will automatically switch to playback during rewind if the counter
equals or is less than 0:00.
•
The Auto Repeat may be adjusted by setting the counter to 00:00. This can
be done by pressing the CLEAR button while the tape counter is on screen
or on the front panel display.
• The counter will not reset while rewinding in an Auto Repeat loop.
Using On-Screen Menus
23
Advertisement
Table of Contents
