Table of Contents
Advertisement
HOW
TO FIND YOURTV'S
VIDEO
INPUT
CHANNEL
You need to tune your TV to the Video Input Channel if you are
using the VCR's AUDIO/VIDEO OUT jacks to connect to the TV's
AUDIONIDEO
INPUT jacks. You must select this "channel"
before
you can see the VCR's menus, the cable or antenna
reception,
and the content
that's on a tape.
The Video Channel on TVs varies for different
brands and
different
models. Below are some steps to try:
•
If your TV brand is RCA, GE, or PROSCAN, press the TV button
on the remote control that came with the VCR. Then press
the INPUT button
on the remote.
•
If you have another
brand of TV, consult the section,
Programming
The Remote, to see if the VCR's remote control
can be set to control your TV. If so, follow the step above.
If those options do not work, try the following
ideas. You might
access the Video Input Channel by:
•
pressing a button
on the remote (see table below)
•
selecting the channel from the TV's menu system
(see table below)
•
tuning
directly to the channel by selecting a specific channel
number (see table below)
•
going through
all the channels in the channel list by pressing
the channel up or down buttons on the TV.
Some common
scenarios are listed in the Video Input Channel
Variations
table that follows:
Video
Input
Channel
Variations
Button/Switch
Button
on the
Channel
on the TV
TV Remote
Number
VIDEO
VID I
OO
SIGNAL
LINE
90
VID 1
VID
91
VID 2
VIDEO
92
S-VID
S-VID
93
S-VIDEO
INPUT
VID 1
S-VIDEO
VID 2
SOURCE
AUX
TV
Button
\
INPUT
Bu_on--
68
Advertisement
Table of Contents
