Using The Input Button - RCA VRM420 User Manual

MENU Displays the VCR MAIN MENU. This is the first step when accessing any on-
screen menu such as LANGUAGE, PREFERENCES, TIMER RECORDINGS, etc.
MUTE Lowers the TV volume to its minimum level. Press the MUTE button again to
restore the TV's volume to its previous level.
ON•OFF Turns the power of the active device (either the TV or VCR) on or off.
PAUSE Pauses playback in VCR mode.
PLAY Starts tape playback in VCR mode.
RECORD Starts and stops recording in VCR mode.
REVERSE Rewinds a tape. In Playback mode, pressing and holding REVERSE starts
reverse playback. In Stop mode, pressing REVERSE fast-rewinds.
SEARCH Displays Index and Go-To Search menus on-screen. Press this button once
to display the Index Search menu and a second time to display the Go-To Search
menu.
SPEED Overrides the set recording speed (either SP or SLP).
STOP Stops the active function of the VCR including tape playback, rewinding, and
fast-forwarding. Pressing the STOP button for several seconds also ejects an inserted
tape.
TRACKING up and down Allows the manual reduction of streaks which may appear
on the picture during regular or slow-motion playback. Reduces picture "jitter" during
play-pause mode.
TV Puts the remote control in TV-operating mode. This button will automatically turn
on most RCA, GE, and Proscan TVs.
TV/VCR Toggles the VCR between TV and VCR-viewing modes.
VCR Puts the remote control in VCR-operating mode.
VOL (up and down) buttons Decreases or increases the TV volume.

Using the INPUT Button

Use the INPUT button to toggle through the available video line input sources (L1, L2,
and regular broadcasting signals) and regular broadcast signals. Video line input allows
you to view the image from a connected device (like a camcorder) through the VCR.
1. Press the remote control's VCR button to place the remote control in VCR-controlling mode.
Make sure that the VCR is turned ON.
2. Press the remote control's INPUT button to tune to the video line input source. L1
represents the rear A/V jacks and L2 represents the front A/V jacks.
3. Press the INPUT button again to tune back to the broadcast signal you were previously
Chapter 3
Using the Remote Control
27