Care And Maintenance - Binatone SI-4060 Instruction Manual

Hide thumbs Also See for SI-4060:

Instruction manual (41 pages)

Table Of Contents

Table of Contents

button (8)

(8)

(8) to produce a directional strong burst of steam from

(8)

the sole plate. Push the button several times with 5-7 seconds

intervals until the article is fully refreshed. If during the process

your water tank (5)

from the mains outlet, wait till it cools down, refill the tank and

plug the appliance back into the power supply and continue the

process.

Using the water spray (7) will help when ironing details of the

article (cuffs, trimmings, plackets, etc) or clothes, which demand

«•» (low temperature) ironing, when steam ironing is not possible.

Push the button several times to moisten the material.

For safety reasons, your iron will automatically stop heating if

it's left:

! upright for 8-15 minutes, or

! flat for 10-30 seconds.

The Operation indicator (1 (1 (1 (1 (11) 1) 1) 1) 1) will flash. The iron will heat up

again when you move it and the operation light will go out.

! To deactivate automatic shut off, stand iron on heel or shake

gently, then the iron will switch on again.

Ionized steaming function

In the dry ironing and steam ironing of process can be used the

ionized steaming function.

Press and hold on the control button (16)

function. The blue internal indicator (17)

ing that smaller steam particles, deeply get into the most difficult

ironing fold, and eliminate the wrinkle to be easier. Light clicking

during this process is a normal occurrence and not a malfunction.

5. When you have finished cleaning or ironing, do not forget to

switch the iron off by putting the steam control knob (9)

temperature control knob (10)

plugging the appliance from the mains supply outlet.