Advertisement
6211 Series (PULL Side) Power Operator
Before You Begin
•
Thickness recommended for
reinforcements in hollow metal doors and
frames is charted.
•
This template information based upon use
of 5" maximum width butt hinges.
•
Maximum frame reveal is 1/8" for 6211 units.
•
Before beginning the installation, verify
that the door frame is properly reinforced
and is well anchored in the wall.
•
Concealed electrical conduit and concealed
switch or sensor wires should be pulled to
the frame before proceeding.
Fasteners for Frame:
•
1/4-20 Machine screws for hollow metal and
aluminum.
•
No. 14 x 2-3/4" (70mm) long sheet metal
screws for wood.
Installation
A. Mount backplate.
1.
Determine right hand or left hand installation.
(Figure 1)
2.
Measure and mark first mounting hole according to
template. (Figure 2)
3.
Attach backplate to frame with screw.
Do not fully tighten screw at this time.
For Metal Frames:
Use #7 drill and 1/4-20 tap for 1/4-20 machine
screws.
For Wood Frames:
Use 3/16" drill and supplied screws for self drilling, self
tapping screws.
4.
Ensure backplate is level and aligned with door frame.
(Figure 3)
5.
Using backplate as guide, mark and drill second hole.
(Figure 3)
6.
Insert second screw and tighten both screws.
7.
Using backplate as a guide, drill and tap remaining
eight (8) holes in frame. (Figure 3)
8.
Secure with eight (8) screws and tighten.
2nd
Hole
Left Hand Shown
Copyright © 2022, ASSA ABLOY Accessories and Door Controls Group, Inc. All rights reserved. Reproduction in whole or in
part without the express written permission of ASSA ABLOY Accessories and Door Controls Group, Inc. is prohibited.
80-9363-0023-020 Rev 1 03/22
Remaining 8 Holes
Approved 2022-06-13
Hollow Metal Door Frame Reinforcing
Frame Material
Recommended
12 Ga.
12 Ga.
.1046
.1046
(2.66)
(2.66)
14 Ga.
10 Ga.
.0747
.1343
(1.90)
(3.41)
16 Ga.
10 Ga.
.0598
.1343
(1.52)
(3.41)
18 Ga.
8 Ga.
.0478
.1644
(1.21)
(4.18)
Right Hand
PULL
Figure 1
Figure 2
Remaining 8 Holes
Figure 3
Fram e
Door
Reinforcing
Min. Required
18 Ga.
.0478
(1.21)
12 Ga.
.1046
(2.66)
12 Ga.
.1046
(2.66)
10 Ga.
.1343
(3.41)
Push Side
Pull Side
Left Hand
PULL
Right Hand Shown
Right Hand Shown
NORTON
RIXSON
1/8"
(3)
Template
2nd
Hole
3
Advertisement
