The Difficulty Levels Change On The Display, But The Perceived By The User Doesn't Change - Rowing Mode - Technogym Skillrow Technical Service Manual

SKILLROW:
Technical Service Guide - Rev. 1.1
6.6.3 THE DIFFICULTY LEVELS CHANGE ON THE DISPLAY, BUT THE PERCEIVED BY
THE USER DOESN'T CHANGE - ROWING MODE
ROWING MODE
The difficulty level changes on
the display, but the perceived
by the user doesn't change.
Verify that the dust is not accumulated inside the fan
[1] and on the grilles. Clean the fan and the grilles.
Problem solved?
Yes
No
OK. Problem Solved.
Check the tension of the two cables [2], that regulate
the resistance of the levels. If necessary, tension the
cables and verify the integrity of them. Calibrate the
equipment. Problem solved?
No
Yes
Replace the angle sensor board.
OK. Problem Solved.
Calibrate the equipment. If necessary,
replace the cable that connects the
angle sensor board to the CPU
mainboard. Calibrate the equipment.
Figure 26
The calibration of the equipment is described at the paragraph "6.7.1 equipment calibration".
Page 58 e-mail: support@technogym.com