Sundance Spas MARIN 880 Series Owner's Manual page 76

880 Series
All models include a suction cover filter (#6540-213) located
directly under the MicroClean Ultra filter cartridge assembly
that prevents debris from entering the hot tub plumbing when
jets pump 1 is running. This filter should be cleaned every 2
months.
TO DECREASE RISK OF DEATH, DROWNING, OR ENTRAPMENT,
ALWAYS TURN POWER TO THE HOT TUB OFF BEFORE REMOVING
THE MICROCLEAN ULTRA FILTER ASSEMBLY!
Filter Cleaning/Replacement Procedure:
1
DANGER:
RISK OF DEATH, DROWNING, OR ENTRAPMENT,
!
NEVER OPERATE SPA WHEN FILTER IS NOT
PROPERLY INSTALLED OR IF WEIR ASSEMBLY IS
DAMAGED OR ALTERED!
2
1
2
Monthly Filter Cleaning Procedure
3
We recommend cleaning the outer pleated filter (1) with a high
pressure water nozzle and the filter insert (2) with a low-pressure
water nozzle monthly. Periodically, the outer pleated filter cartridge
(1) will require a more thorough cleaning to remove embedded oils
and minerals by using special spa filter cleaners offered by your spa
dealer. Always remove the center filter insert (2) before cleaning the
outer filter (1) with chemicals. Never use filter cleaners of any kind
on the filter insert (2) or it may be damaged, come apart or allow
impurities to re-enter the water, increasing the risk of contracting
a waterborne illness (e.g. an infection, bacteria or virus) and/or
respiratory ailments.
Procedure:
1. Grasp center filter insert end cap (2) in hand and pull outward from
pleated cartridge (1). If filter insert (2) is 6 months old, throw it away
and purchase new one. DO NOT install new insert at this time.
70
TURN POWER TO SPA OFF! TO DECREASE
Filter Cleaning Requirements:
• Clean MicroClean Ultra Pleated
Filter (1) monthly and replace every
Filter Nut
18 months (6473-165).
• Rinse off MicroClean Ultra Insert (2)
monthly and replace every 6 months
or as needed (6473-164).
Filter Removal Instructions:
Loosen filter nut to provide clearance,
then remove MicroClean Ultra Filter
Assembly from spa.
!