Removing The Cabinet Panels - Sundance Spas MARIN 880 Series Owner's Manual

2. Rinse debris from all outer filter
(1) pleats using a garden hose
and high-pressure nozzle. Repeat
process until all filter pleats are
clean. Then rinse debris from
inside of filter (1). If chemical
cleaners are used, follow
manufacturers instructions.
Lightly rise filter insert (2) and
place in clean location. *DO
NOT use chemical cleaners or high-pressure nozzle on insert (2) or
it may be damaged, come apart or allow impurities to re-enter the
water, increasing the risk of contracting a waterborne illness (e.g. an
infection bacteria or virus) and/or respiratory ailments.
3. Install filter insert (2) into outer pleated filter (1) by gently sliding
inward until a slight resistance is felt approximately 1/4" from bottom.
Lightly tap insert end with palm of hand to "snap" in place. Insert is
properly installed when end cap rests "flush" against outer filter end
cap.
4. Install Filter assembly back into spa by performing step 2 in reverse
order. Tighten filter nut so it just touches the filter face. DO NOT
OVERTIGHTEN!
5. Turn power to spa back on.
Replacement filter cartridges may be purchased from your Sundance
Spas dealer.
13.2

Removing the Cabinet Panels

The SunSide Skirt panels provide easy access
to the equipment bay and components without
having to unscrew the panel. To remove the skirt
panels follow the steps below:
1. Grab one of the corner panels, from the
bottom, where it touches the bottom pan.
Then gently pull the panel forward to unsnap
it from the holding clip then pull down to
remove, Figure A. Place the panel in a safe
location to prevent from damaging it. Repeat
the steps to remove the other corner panel.
Note: The corner exterior lights on the panels
are connected to the light wires. Take care when
removing the corner panels to avoid damaging
the wires.
1
1
Top
880 Series
2
2*
102 °
Figure A
102 °
Figure B
102 °
71