Transmitter Connections And Switch - Extron electronics DTP T DP 4K 330 User Manual

Transmitter Connections and Switch

DisplayPort input port (see
A
digital video input to this DisplayPort connector. The transmitters also accept
embedded digital audio on this port.
Audio input connector — If desired, plug an analog audio input into the
B
transmitter via this stereo mini jack connector.
NOTES:
•
•
Over TP RS-232 and IR connector — Connect a serial RS-232 signal,
C
a modulated IR signal, or both to this 3.5 mm, 5-pole captive screw
connector for bidirectional RS-232 and IR communication
(see RS-232 and IR connector wiring
TP function switch — If the receiving device is in the Extron DTP series, set this
D
switch to the DTP position. For an HDBaseT-enabled receiver type, set this switch
to the HDBT position. This switch tailors the output signal as follows:
HDBT position — The TP output consists of DisplayPort video with embedded digital
audio plus RS-232 and IR.
DTP position — The TP output consists of DisplayPort video with embedded digital
audio, analog audio, RS-232 and IR, and remote power.
ATTENTION:
•
•
NOTES:
•
•
DTP T/R DP 4K 330 and DTP T/R DP 4K 230 Twisted Pair Extenders • Installation and Operation
figure 2
The analog audio input on this connector is
not embedded into the digital signal and is
in addition to the digital audio that may be
already embedded in the DisplayPort input.
See figure 4 to identify the connector tip, ring,
and sleeve when you are making connections
for the transmitter from existing audio cables.
A mono audio connector consists of the
tip and sleeve. A stereo audio connector
consists of the tip, ring, and sleeve.
Position this switch BEFORE connecting the appropriate device to the TP
connector. Failure to comply can damage the endpoint.
Positionnez le sélecteur AVANT de connecter l'appareil approprié au
connecteur TP. Ne pas respecter cette procédure pourrait endommager le
point de connexion.
When the switch is in the HDBT position, the transmitter and receiver each
requires a local 12 VDC power supply.
When the switch is in the DTP position, one 12 VDC power supply,
connected to either the transmitter or the receiver, can power both units.
on the previous page) — Connect a
Tip (+)
Ring (-)
3.5 mm Stereo Plug Connector
Figure 4.
on page 10 to wire the connector).
DISPLAYPORT
Sleeve ( )
(balanced)
TRS Connector
Wiring
OVER TP
RS-232 IR
Tx Rx G Tx Rx
HDBT
DTP
4