Installation And Operation; Mounting The Units; Connections; Transmitter Connections - Extron electronics DTP DVI 330 User Manual

Installation and
Operation
This section describes the installation and the operation of the DTP DVI 330 Tx/Rx Extender,
including:
•
•
•

Mounting the Units

ATTENTION:
Mounting instructions and the applicable optional hardware can be found in
Transmitter or Receiver
transmitter or receiver can be placed on a tabletop, mounted on a rack shelf, or mounted
under a desk or tabletop. The receiver can also be mounted on a projector bracket.

Connections

Transmitter Connections

DDC ROUTE
POWER
REMOTE
12V
0.8 A MAX
ON
1 2
SPARE LOCAL
Rear
.
6
Figure 2.
a
Mounting the Units
Connections
Operation
• Installation and service must be performed by authorized personnel only.
• Avoid ground potential differences between the transmitter and receiver installation
sites, which can lead to equipment damage or a missing or unstable picture. If
a potential difference cannot be avoided, remove the ground connection between
the units and locally power both units (see
page 12). In this configuration, the DTP DVI 330 cannot extend analog audio and
each unit requires a local power supply.
on page 11. The 1-inch high, quarter rack width DTP DVI 330
OVER DTP
SIG LINK
RS-232 IR
DTP OUT
Tx Rx G Tx Rx
5 4
DTP DVI 330 Tx Connectors
DVI-D connector — Connect a DVI cable between this port and the DVI output port
(or HDMI, with an appropriate adapter) of the digital video source.
DTP DVI 330 Tx/Rx Transmitter and Receiver • Installation and Operation
Disconnecting the Ground
INPUTS
DVI-D
AUDIO
Front
3 1
on
Mounting the
LOCAL OUTPUT
DTP DVI 330 Tx
2
3