Table of Contents
Advertisement
TP Output RJ-45 connector (see
E
of a TP cable to this RJ-45 female connector on the transmitter. Ensure the
opposite end of this cable is connected to the receiver TP Input RJ-45
connector (see item
ATTENTION:
•
Do not connect these devices to a telecommunications or computer data
network.
•
Ne connectez pas ces appareils à des données informatiques ou à un réseau
de télécommunications.
NOTE: See
wire the RJ-45 connectors and for detailed NOTES.
Signal LED — Indicates the unit is receiving a DisplayPort signal on the DisplayPort
input.
Link LED — Indicates a valid link is established between the units on the DTP input
and output cable.
Power connector — Plug the included external 12 VDC power supply into either this
F
2-pole connector or the power input connector on the receiver (see
ATTENTION:
•
Do not connect power to the DTP T/R DP 4K 330 or DTP T/R DP 4K 230 until
you have read the
•
Ne branchez pas l'alimentation au DTP T/R DP 4K 330 ou DTP T/R DP 4K 230
avant d'avoir lu les deux rubriques «
NOTE: When the TP function switch (see
position, one power supply can power both units.
When the TP function switch is in the HDBT position, the transmitter
and receiver each requires a local 12 VDC power supply.
Power LED —
Amber — The unit is receiving power remotely (on the DTP cable).
Green — The unit is receiving power locally.
DTP T/R DP 4K 330 and DTP T/R DP 4K 230 Twisted Pair Extenders • Installation and Operation
figure 2
, below).
G
TP cable termination and recommendations
CAUTION
and
ATTENTION
on page 3) — Connect one end
on page 7 to properly
item
notices on pages 9 and 10.
ATTENTION
» aux pages 9 et 10.
item
on page 4) is in the DTP
D
SIG
LINK
OUT
on page 7).
K
5
Advertisement
Table of Contents
