To Power Your Camcorder - RCA CC180 Owner's Manual

Video camcorder
Table of Contents

Advertisement

Caution:
M
e sure the camcorder's power is turned off
when you attach or remove a power supply. Removing
the power supply during recording or playback may cause
damage to the tape.
Using the AfapterKharger to Power Your
Camcorder
I
PO WEd
Indicator
Power C+umecto2
power connector attaches' to the
power your camcorder directly from
operates on lOOi volts, 50160 Hz, it can be used virtually
anywhere in the world.
Note: A plug addpter
may be required in some countries. Consult
traveling, as the adapter may be hard to find in
wer connector's small
on the adapter/charger.
To Remove then Adapter/Charger
ile sliding the power connector to the left
6
AC Adapter/Charger
BATTERY RELEASE
Button
Because the adapter/charger
into the
plug
the back of the
from the wall outlet.
RELEASE button on the
Using the Battery to Power Your Camcorder
The
must be charged before it can be used the first
battery
time. Initial charging will take approximately 1 -l/2 hours.
When fully charged, the battery should supply about 55
minutes of operating time (depending on how much you
zoom and pause).
Note: The small marker switch on the top
as a personal reminder to help you remember to recharge the battery.
It has no other function.
Charging the Battery
P O W E R
CHARGE
Indicator
Caution:
When a battery is attached to the adapter/
charger, do not turn them upside down.
fall off and be damaged or
cause
If the power connector is attached to the adapter/charger,
remove its plug.
1. Align the reference marks on the battery with the mark on
the adapter/charger.
2. Hotd the battery flush against the adapter/charger and slide
it in the direction of the arrow.
3. Plug the adapter/charger into the nearest AC outlet
( 100-24OV. 50/6OHz).
4. If the battery is properly connected, the adapter/charger's
CHARGE indicator will light. When the light turns green,
the battery is fully charged.
5. Remove the charged battery by sliding it off the
adapter/charger.
6. Attach the charged battery to the camcorder as shown on
the next page.
u s e
battery is for
of the
use
Reference
To AC Outlet
The
battery may
injury.
(continued on next page)

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents