Table of Contents
Advertisement
NetVanta 3200/3300/3400 Series
Installing the Octal PoE Upgrade Module
The NetVanta Octal PoE Upgrade provides the ability to detect attached PDs and deliver 48 VDC to the
PDs via existing CAT 5 and CAT 6 cabling. If your NetVanta 3448 or NetVanta 3458 did not originally
come with PoE capability, it can be upgraded using the Octal PoE Upgrade. The Octal PoE Upgrade is
shipped with the Octal PoE module, two standoffs, the Octal PoE power supply, and appropriate power
cords.
Instructions for Installing the Octal PoE Upgrade Module
Step
1
Remove power from the unit and all connecting cables from the unit.
2
Remove any installed NIMs.
3
Remove the screws holding the base unit and the cover together, the two jack screws from the back panel
(if necessary), and the two mounting brackets (if necessary). See
4
Carefully lift and remove the unit's cover to expose the circuit board.
5
Remove the two PC board mounting screws (do not discard). See
6
Thread and secure the two standoffs (supplied with the NetVanta Octal PoE module) into the two holes from
which you removed the PC board mounting screws.
7
Carefully align the 34-pin receptacle on the Octal PoE module with the 34-pin header located on the circuit
board. Applying even pressure, press the module until it is well seated.
8
Align the holes in the standoffs with the holes in the Octal PoE module. Attach the module to the standoffs
using the two previously removed PC board mounting screws.
9
Replace the unit cover, screws, mounting brackets, NIMs, and all connecting cables.
10
Restore power to the unit following the instructions in
page
66.
Electronic modules can be damaged by static electrical discharge. Before handling
modules, wear an antistatic discharge wrist strap to prevent damage to electrical
components. Place modules in antistatic packing material when transporting or storing.
When working on modules, always place them on an approved antistatic mat that is
electrically grounded.
The NetVanta Octal PoE Upgrade Module is intended to be installed only by qualified
service personnel.
61200860L1-34AE
Action
Powering the NetVanta with Octal PoE Upgrade on
Copyright © 2019 ADTRAN, Inc.
Unit Installation
Figure 42 on page
78.
Figure 42 on page
78.
77
Advertisement
Table of Contents
