Advertisement
N
V
ET
ANTA
P/N 1203860G1
G
S
ETTING
TARTED
Two configuration methods are available for your NetVanta router:
•
Web-based graphical user interface (GUI)
•
AOS command line interface (CLI)
The GUI lets you configure the main unit settings and provides online guidance and explanations
for each setting. However, using the AOS CLI may be necessary for more advanced
configurations.
A
GUI
CCESS THE
You may access the GUI from any Web browser on your network by following these steps:
1.
Connect the router to your PC using the ETH 0/1 port on the back of the unit.
2.
Set your PC to a fixed IP address of 10.10.10.2. If you cannot change the PC's IP address,
you will need to change the unit's IP address using the CLI. (Refer to the next two sections
for instructions.)
3.
Enter the unit's IP address in your browser address line. The default IP address is
10.10.10.1.
4.
You will then be prompted for the user name and password (the default settings are admin
and password).
5.
The initial GUI screen appears.
A
CLI
CCESS THE
Access the AOS CLI via the CONSOLE port or a Telnet session. To establish a connection to the
NetVanta router CONSOLE port, you need the following items:
•
VT100 terminal or PC (with VT100 terminal emulation software)
•
Straight-through serial cable with a DB-9 (male) connector on one end and the appropriate
interface for your terminal or PC communication port on the other end
1.
Connect the DB-9 (male) connector of your serial cable to the CONSOLE port on the rear
panel of the unit.
2.
Connect the other end of the serial cable to the terminal or PC.
3.
Insert the connector of the provided power cord into the power interface on the rear panel of
the unit, and plug the cord into a standard electrical outlet.
4.
Once the unit is powered up, open a VT100 terminal session using the following settings:
9600 baud, 8 data bits, no parity bits, and 1 stop bit. Press <Enter> to activate the
AOS CLI.
5.
Enter enable at the > prompt.
6.
Enter the enable password when prompted. The default password is password.
Quick Start Guide, 61203860G1-13B, March 2008
3200 R
OUTER
1
Advertisement
Table of Contents
Related Manuals for ADTRAN NETVANTA 3200
Summary of Contents for ADTRAN NETVANTA 3200
- Page 1 3200 R ANTA OUTER P/N 1203860G1 ETTING TARTED Two configuration methods are available for your NetVanta router: • Web-based graphical user interface (GUI) • AOS command line interface (CLI) The GUI lets you configure the main unit settings and provides online guidance and explanations for each setting.
- Page 2 NABLE ELNET CCESS The following steps create a password of adtran for Telnet access. By default, Telnet access is enabled with a password of password. Verify that the prompt of your unit displays (config)#. Enter line telnet 0 4 to change the configuration parameters for the Telnet sessions.
- Page 3 ONFIGURE PPLICATION More detailed documentation for configuring your ADTRAN unit is provided on the AOS Documentation CD included in your shipment. For more detail on hardware setup, refer to the appropriate NIM quick start guides and the hardware installation guide. For more detail on configuring your system, refer to the AOS Command Reference Guide, configuration guides, and technical support notes.
- Page 4 Copyright © 2008 ADTRAN, Inc. All Rights Reserved.
Need help?
Do you have a question about the NETVANTA 3200 and is the answer not in the manual?
Questions and answers