Table of Contents
Advertisement
Unit Installation
Instructions for Wall Mounting NetVanta 3450/NetVanta 3458
Step
1
Remove the mounting ears. Rotate them 90
flush with the bottom of the chassis, and reattach them to the chassis (see
2
Decide on a location for the unit. Keep in mind that the unit needs to be mounted at or below eye level so
that the LEDs are viewable.
Important! Mount the chassis with LEDs facing to the side as shown in
down).
3
Prepare the mounting surface by attaching a board (typically plywood, 3/4-inch to 1-inch thick) to a wall
stud using #6 to #10 (2.5-inch or greater in length) wood screws.
Important! Mounting to a stud ensures stability. Using sheetrock anchors may not provide
sufficient long-term stability.
4
Have an assistant hold the unit in position as you install two #6 to #10 (1-inch or greater in length) wood
screws through the unit's brackets and into the mounted board. See
5
Proceed to the steps given in
Figure 32. Wall Mounting the NetVanta 3450 and NetVanta 3458
Supplying Power to the Unit
As shipped, each NetVanta 3200/3300/3400 Series is set to factory default conditions. After installing the
base unit and any option modules, the NetVanta is ready to be powered. To power the unit, ensure that the
unit is properly connected to an appropriate power source (as outlined in the sections that follow).
64
Action
o
so that the portion of the bracket with the mounting holes is
Supplying Power to the Unit on page
Copyright © 2019 ADTRAN, Inc.
NetVanta 3200/3300/3400 Series
Figure
32).
Figure 32
(not facing up or
Figure
32.
64.
61200860L1-34AE
Advertisement
Table of Contents
