Safety Instructions; Regular Maintenance - DSC neo HS2128 E User Manual

Chapter
11

11.0 Safety Instructions

This equipment is stationary-fixed and must be installed by Skilled Persons only (Skilled Person is
defined as a person having the appropriate technical training and experience necessary to be aware of
hazards to which that person may be exposed in performing a task and of measures to minimize the risks
to that person or other persons). It must be installed and used within an environment that provides the pol-
lution degree max 2, over voltages category II, in non-hazardous, indoor locations only.
When using equipment connected to the mains and/or to the telecommunication network,
WARNING!
there are basic safety instructions that should always be followed. Refer to the safety instructions
provided with this product and save them for future reference. To reduce the risk of fire, electric
shock and/or injury, observe the following:
Do not attempt to service this product yourself. Opening or removing the cover may expose you to
l
dangerous voltage or other risk. Refer servicing to Skilled Persons only.
Use authorized accessories only with this equipment.
l
Do not leave any object on the top of the cabinet of this equipment.
l
Do not spill any liquids on the cabinet.
l
Do not touch the equipment and its connected cables during a lightning storm; there may be a
l
risk of electric shock.
Ensure that cables are positioned so that accidents cannot occur.
l
Do not subject cables to an excessive mechanical strain.
l

11.1 Regular Maintenance

Keep your Alarm Controller in optimal condition by following all the instructions that are included within
this manual and/or marked on the product. It is the end-user and/or installer's responsibility to ensure that
the disposal of the used batteries is made according to the waste recovery and recycling regulations
applicable to the intended market.
Cleaning
Clean the units by wiping with a damp cloth only.
l
Do not use abrasives, thinners, solvents or aerosol cleaners (spray polish) that may enter through
l
holes in the Alarm Controller and cause damage and/or create hazards.
Do not use any water or any other liquid.
l
Do not wipe the front cover with alcohol.
l
NOTE: There are no parts replaceable by the end-user within this equipment, except for the keypad bat-
teries. Dispose of used batteries as per local rules and regulations.
- -
40