Safety Instructions; Regular Maintenance And Troubleshooting; Cleaning; Troubleshooting - DSC Neo HS2016 User Manual

Chapter 13

13.0 Safety Instructions

This equipment is stationary-fixed and must be installed by Service Persons only (Service Person is defined as a person having the
appropriate technical training and experience necessary to be aware of hazards to which that person may be exposed in performing
a task and of measures to minimize the risks to that person or other persons). It must be installed and used within an environment
that provides the pollution degree max 2, over voltages category II, in non-hazardous, indoor locations only.
WARNING! When using equipment connected to the mains and/or to the telecommunication network, there are basic safety
instructions that should always be followed. Refer to the safety instructions provided with this product and save them for future ref-
erence.To reduce the risk of fire, electric shock and/or injury, observe the following:
Do not attempt to service this product yourself. Opening or removing the cover may expose you to dangerous voltage or
l
other risk. Refer servicing to qualified service persons. Never open the device yourself.
Use authorized accessories only with this equipment.
l
DO NOT leave and/or deposit ANY object on the top of the cabinet of this equipment! The cabinet as it is installed on
l
the wall is not designed to support any supplementary weight!
Do not spill any liquids on the cabinet.
l
Do not touch the equipment and its connected cables during an electrical storm; there may be a risk of electric shock.
l
Never touch uninsulated wires or terminals unless the equipment has been disconnected from the mains supply and from
l
the telecommunication network!
Ensure that cables are positioned so that accidents cannot occur. Connected cables must not be subject to excessive mech-
l
anical strain. Do not spill any type of liquid on the equipment.
Do not use the Alarm system to report a gas leak if the system is near a leak.
l
Do not subject the connected cables to an excessive mechanical strain.
l
These safety instructions should not prevent you from contacting the distributor and/or the manufacturer to obtain any further cla-
rification and/or answers to your concerns.

13.1 Regular Maintenance and Troubleshooting

Keep your Alarm Controller in optimal condition by following all the instructions that are included within this manual and/or
marked on the product. It is the end-user and/or installer's responsibility to ensure that the disposal of the used batteries is made
according to the waste recovery and recycling regulations applicable to the intended market.

13.1.1 Cleaning

Clean the units by wiping with a damp cloth only.
l
Do not use abrasives, thinners, solvents or aerosol cleaners (spray polish) that may enter through holes in the Alarm Con-
l
troller and cause damage and/or create hazards.
Do not use any water or any other liquid.
l
Do not wipe the front cover with alcohol.
l

13.1.2 Troubleshooting

Occasionally, you may have a problem with your Alarm Controller or telephone line. If this happens, your Alarm Controller will
identify the problem and displays an error message. Refer to the provided list when you see an error message on the display. If
additional help is required, contact your distributor for service.
Note: There are no parts replaceable by the end-user within this equipment, except for the keypad batteries. Dispose of used bat-
teries as per local rules and regulations.

13.1.3 Applicable Models

This publication covers the following models x = 9 (912-919MHz UL/ULC systems), 4 (433MHz) or 8 (868MHz).
HS2016 HS2LCD
HS2128 HS2LCDP
HS2032 HS2LCDRFx
HS2064 HS2LCDRFPx
HS2LCDWFx HS2ICN
HS2LCDWFPx HS2ICNP
HS2LCDWFPVx HS2ICNRFx
HS2LED HS2ICNRFPx
- 38 -
HS2TCHP