Ct Classic™ Start-Up Procedures; How To Turn On The Appliance; How To Preheat The Appliance - Alto-Shaam COMBITHERM CT PROFORMANCE CTP10-10E Installation Manual

How To Turn On the Appliance

Prerequisites
1. Turn on the exhaust hood.
2. Make sure that the water supply to the appliance is turned
on.
3. Make sure that the electrical power supply to the appliance
is turned on.
4. For gas applicances, make sure the gas supply valve is in
the open position.
Steps
1. Press the ON/OFF button
green.
NOTE: If the appliance has a steam generator, the steam
generator fills with water and the appliance heats the
water to an initial temperature of 188°F (77°C).
NOTE: To power off the appliance, press and hold the Power
button for 5 to 10 seconds to initiate the power shut
down sequence to the oven.
How To Run a Cycle Test of the Appliance
Run the cycle test in combination cook mode
2. Press the combination cook mode button
3. Press the cook temperature button
4. If necessary, use the up arrow button
button to set the cooking temperature to 350°F (177°C).
9
5. Press the cook time button
6. Use the up arrow button
enter the cooking time (00:15:00).
7. Press the start/stop button
cooking.
8. Make sure that the appliance cycles correctly.
1. The appliance raises the cavity temperature to the set
temperature.
2. The appliance cycles off by itself when the set
temperature is reached.
3. The appliance idles until the cavity temperature drops
below the set temperature.
4. The appliance cycles back on by itself until the cavity
temperature again reaches the set temperature.
Allow the appliance to run through several cycles.
Cool down the appliance
1. Press the start/stop button
2. Press the cool down button
3. Use the up arrow button
set the cool down temperature to 110°F (43°C).
4. Open the appliance door.
NOTE: The cook time field
not open.
MN-35947
•
. The ON/OFF indicator glows
1
.
2
.
3
or the down arrow
5
.
4
or the down arrow button
5
. The appliance begins
10
to stop the cooking process.
10
.
7
or the down arrow button
5
diplays "dOOr" if the door is
8
Rev 18 05/19 Combitherm® CT PROformance™ and CT Classic Series Installation Manual
• •
CT Classic™ Start-Up Procedures
NOTICE:
In the event of a power failure, the oven will not
operate.
1
2
to
9
3
4
5
5. Press the start/stop button
The cook time field
The fan turns off when the cavity temperature matches the
set cool down temperature.
Run the cycle test in convection cook mode
1. Press the convection cook mode button
to
9
2. Repeat the cycle test steps for convection cook mode.
3. Cool down the appliance when the cycle test is complete.
DANGER
Before starting the appliance, make certain you
do not detect the odor of gas.
If you smell gas:
• Shut off the gas supply immediately.
• Do not attempt to light any appliance.
• Do not touch any electrical elements.
• Extinguish any open flame.
• Evacuate the area.
• Use a telephone outside the property and
immediately contact your gas supplier.
• If unable to contact your as supplier, contact the
fire department.
C A U T I O N
Accumulations on the main burners of gas
appliances can result in firing out of normal
sequence. This delayed ignition creates an
alarmingly loud sound. If your appliance makes
an especially loud noise when starting up, shut
down the appliance and call a qualified and
trained service technician.
160°F
00:00
10
. The fan activates.
10
displays the cavity temperature.
8
5
•
5
6
7
8
9
.
69