Table of Contents
Advertisement
Advanced operation
4.7 Hibernate
About hibernate
When hibernate is enabled, not only the backlight will be switched off, but also other functionalities will be
disabled to further reduce power consumption to a minimum. This happens after a specific period of time
which can be manually adjusted.
Hibernate can only be enabled on your display when the DPMS mode is enabled first. Therefore,
please refer to "DPMS mode", page 25 to do this.
Please connect your keyboard or mouse to your PC rather than to the display's USB ports when
hibernate is enabled.
To enable/disable hibernation on your display:
1.
Bring up the OSD main menu.
2.
Navigate to the Configuration > Power Management menu.
3.
Enter the Hibernate submenu.
4.
Select Enabled/Disabled as desired and confirm.
To specify the hibernate time-out:
1.
Bring up the OSD main menu.
2.
Navigate to the Configuration > Power Management menu.
3.
Enter the Hibernate Timeout submenu.
4.
Set the time-out value as desired and confirm.
4.8 Luminance target
About the luminance target
The luminance target of your Coronis Fusion 4MP / 6MP is adjustable over a predefined range. When you
change the luminance target, the display will adjust its backlight to reach the target.
To set the luminance target:
1.
Bring up the OSD main menu.
2.
Navigate to the Configuration > Calibration menu.
3.
Enter the Luminance Target submenu.
4.
Set a luminance target value as desired and confirm.
The default, factory DICOM calibrated luminance value is available in the technical specifications
table. The guaranteed backlight lifetime is valid for this setting.
4.9 Color presets
About color presets
The available color preset settings for your display are:
•
Clearbase: Simulation of the clearbase film color temperature.
•
Bluebase: Simulation of the bluebase film color temperature.
26
K5902108 /06
Coronis Fusion 4MP / 6MP
Advertisement
Table of Contents
