Technical Parameters; Operation Conditions - Kernau KBH 07601.1 X Manual Instruction

Hide thumbs

Table of Contents

Available languages

Efficiency

Rated voltage

Total power

Lightbulb power

Air outlet

1. When installing the device, comply with the conditions and guidelines contained in

these instructions for use.

2. The manufacturer declines all responsibility for damages resulting from the installation

inconsistent with the information given in this manual.

3. The hood may differ in appearance from the hood shown in the drawings of this manual,

but the recommendations for operation, maintenance and assembly remain unchanged.

4. The device is intended for home use. The warranty conditions change when used for the

catering business.

5. Keep the operating instructions in order to be able to use them at any time. If you sell

the device or move out form your residency, make sure that the operating instructions

are included with appliance.

6. Carefully read the operating instructions, which provide accurate information regarding

installation, use and care of the device.

7. Do not make any electrical or mechanical changes to the device or the drain lines.

8. Do not pull the plug out of the socket by pulling the cord.

9. The power cord must not touch a hot surface.

10. Do not operate the device if the power cord is damaged.

11. Any changes made to the construction of the hood by persons without the appropriate

permissions result in exclusion of the manufacturer's liability for the product.

12. The hood should never be used as a support surface, unless such possibility has been

clearly indicated.

13. The kitchen hood is used to remove kitchen vapors outside, it should be connected to

adequate ventilation duct (do not connect it to chimney, smoke, flue ducts in use).

14. If, in addition to the hood, other non-electric devices are used in the room (e.g. liquid

fuel stoves, flow heaters, thermostats), sufficient ventilation should be ensured.

15. Unplug the appliance from the socket before each cleaning operation, filter change or

before carrying out any repair work.

16. Do not connect the device to the mains before completing assembly.