Possible Upgrade Problems; Embedded Diagnostics; Reinstalling The Transport Lock; Transport Lock Installation Procedure - Quantum FastStor 1 User Manual

FlashIt utility.
6. Start the FlashIt utility and follow the instructions in the program.
To verify that the firmware version in the tape drive is correct, enter the View
Data menu from the front panel. Select the "Drive Info" and from there the
"Drive FW Revision" entry to see the revision number.

Possible Upgrade Problems

If a power loss or a failure occurs during code download and ECC Checking,
the original firmware might be intact. It is possible to restart the firmware
upgrade procedure. However, if the failure occurs during flash erase or
programming, the firmware will be corrupted and a special procedure must be
used to load a new code. Contact your Technical Support Representative for
assistance.

Embedded Diagnostics

The FastStor 1 includes two levels of diagnostics:
• The Power-On Self Test (POST) — Performs several verification and
memory tests when you power on the unit.
• User Diagnostics — Selectable from the front panel

Reinstalling the Transport Lock

Before the
FastStor 1 is
shipped over a
distance, the
transport lock
must be installed.
The transport lock
prevents damage
to the robotics
during transport
and handling.
Note: Damage to
the robotics during
shipping will not
be covered by
warranty unless
the transport lock
is installed.

Transport Lock Installation Procedure

To insert the locking screw, do the following:
52
Figure 6.1 Transport lock marked with
red plastic tab
FastStor 1 Installation and User Guide