Figure 3.5 Slide The Faststor 1 In From The Front; Figure 3.7 Fasten The Rear Of The Faststor 1 To The Rails - Quantum FastStor 1 User Manual

Mounting the FastStor 1 to the Rack
Make sure all the screws in the Rack Mounting Kit are tightened properly before
installing the FastStor 1 in the rack.
Slide the FastStor 1 on the rails from the front of the rack, as shown in figure 3.5.
Then fix the FastStor 1 using one M6x12 screw in front of the rack on both left and
right side (see figure 3.6) and one M5x8 on the backside of the Rack Mounting Kit
on both left and right side (see figure 3.7).
Figure 3.5 Slide the FastStor 1 in from
the front

Figure 3.7 Fasten the rear of the FastStor 1 to the rails.

How to dismount the FastStor 1 from the rack
Make sure you have disconnected all cables before you start dismounting the
FastStor 1 from the rack.
Unscrew the M5x8 screws at the back of the rack mounting kit. (See figure 3.7)
Unscrew the M6x12 screw at the front of the rack. Note that you only unscrew the
lowest screw. (See figures 3.5 and 3.6)
14
Figure 3.6 Fasten the front of the
Use one M5x8 screw on both left
and right side (M5-thread) to
fasten the FastStor 1 to the rails'
backside.
FastStor 1 to the rack
FastStor 1 Installation and User Guide