Faststor 1 Info - Quantum FastStor 1 User Manual

Select button. The loader will remain in its ready state when this menu is selected.
The View Data menu contains the values assigned during device setup (see Setup
Menu), and also statistical data related to the drive and the robotics. The view-only
fields display data that can be changed from the Setup menu only. If you select the
Change button and the robot is idle, a dialog appears where the value may be
changed. This requires entering a password if the Loader Password system is
enabled.
Item name

FastStor 1 info

SCSI info
Remote
Management info
Statistics
FastStor 1 Info
An overview of the possible values for each FastStor 1 setting is listed in the
following table.
Item name
Cleaning Slot
Barcode Reader
Loader Serial No.
Loader FW
revision
Loader Vendor ID
Loader Product
ID
Loader SCSI ID
Loader Parity
Loader Slots
State
Loader
personality
Audible Alarm
FastStor 1 Installation and User Guide
Description
This menu item gives access to the FastStor 1 view
menu.
This menu item gives access to the SCSI bus view
menu. Both the FastStor 1 and the Drive SCSI bus
parameters are available here.
This menu gives access to the Selected IP addresses
and masks. This menu also shows the MAC address
of the unit.
This menu item gives access to the loader's view
menus internal count and statistics values.
Legal values.
Defined cleaning slot,
Disabled
Enabled, Disabled
Loader Serial number.
FastStor 1 FW id and
revision
Current Inquiry Vendor Id
Current HW/FW Product Id
SCSI Id 0 to SCSI Id 15
Disabled, Enabled
View status for each loader
slot
FastStor 1
Enabled, Disabled
Default value
Disabled
Enabled if installed, else
Disabled
---
xx.yy
"ADIC"
AT3200-1R LTO2
SCSI ID = 4
Enabled
Not applicable
FastStor 1
Disabled
31