Remote Management Web Pages; Information Boxes; Figure 5.1 Navigation Menu - Quantum FastStor 1 User Manual

Addr. mode to DHCP mode.
3. Via the front panel, first set Setup → Remote management → Access
control → Allow remote man. to "Not allowed" and select "OK." Then set
the same value to "Allowed" and select "OK." This will restart the networking
subsystem. Obtaining a new IP address may take some time if the FastStor
1 is in DHCP mode.
4. Check the IP address via the front panel by accessing either View Data →
Remote man. info → Sta IP Addr. state or View Data → Remote man.
info → Dyn IP Addr. state, depending on whether the FastStor 1 is in static
or dynamic IP address mode.

Remote Management Web Pages

Most of the operations you can perform from the front panel can also be
performed remotely using Web Administration. The Remote Management
interface provides access to loader and drive status and statistical operation
information.
The Web pages include a
navigation menu making it
easy to use, see Figure 5.1.

Information Boxes

All the Remote Management web pages show FastStor 1 and drive information.
This information includes:
• FastStor 1 information containing model, serial number, firmware
version, cumulative power-on time and present activity of the loader.
• Drive information containing technology, serial number, firmware version
and activity
42
Status
Settings
Personalization
Network
SCSI-ID
Cleaning options
Command
Maintenance
Diagnostics
Debugging
FW upgrade

Figure 5.1 Navigation Menu

FastStor 1 Installation and User Guide