Preparing The Rack - Quantum FastStor 1 Install Manual

Preparing the Rack

Refer to the following illustration while performing Steps 1and 2:
Line up ends when
installing rails,
approximately as
shown
Verify the alignment of the ends of the two front slide/rail assemblies (#13). The front edge of the slide rail should be aligned
1.
with the notch in the front outer rail-adapter as shown in Rail Position Detail in the illustration. If necessary, adjust the
alignment of each rail assembly by loosening the two panhead screws (#3), reposition the ends of the slide rail until aligned,
then tighten the two screws.
Using two slotted, panhead screws (#3), two flat washers (#6), and two Kepnuts (#4) for each assembly, attach the rear outer
2.
rail-adapters (#14) to the front slide/rail assemblies (#13) as shown. Do not fully tighten the screws at this time. Ensure that
the flange on the rear outer rail adapter is facing the same direction as the flange on the front slide/rail assemblies, as shown
in the illustration.
4
Front outer rail-adapter
Rail Position Detail
FastStor Rack Mount Installation Instructions
14 Rear outer rail-adapter
13 Slide/rail assembly
3
Slide rail
3 8 places
6
4
6
4
62-0125-01