3. Mount the front of the left-hand inner slide rail (#15) to your FastStor at the front mounting-hole using a slotted, pan head
screw (# 3). Refer to the illustration below for the location of the front mounting-hole.
4. Secure the rear of the left-hand inner slide rail (#15) to your FastStor at the rear mounting-hole using a slotted, pan head
screw (# 3) and a Kepnut. Reach inside the rear opening of your FastStor and install the Kepnut (#4) onto the screw (#3).
Refer to the exploded view in the following illustration for the location of the mounting-hole inside your FastStor.
Note: be careful to not disturb the blue and brown wires that connect the AC input module to the power supply.
5. Re-install the drive assembly and secure the rear panel with the seven screws removed previously.
6. Return to section: Installing Kit Components earlier in this document.
62-0125-01
15
Inner Rail
3
FastStor Rack Mount Installation Instructions
Front
Mounting-Hole
2 Places
4
3
Rear Mounting-Hole
15