Installing The Faststor/Support Box Assembly Into The Rack - Quantum FastStor 1 Install Manual

Installing the FastStor/Support Box Assembly into the Rack

With an assistant, lift the FastStor/support box assembly into position, and then guide the slides mounted on the FastStor and
1.
support box into the slide rail assemblies on the rack.
Push the FastStor/support box assembly rearward, until the front mounting brackets contact the rack's vertical mounting rails.
2.
Install a cage nut in the mounting hole of each of the vertical mounting rails that lines up with the thumbscrews on the front
3.
mounting brackets. The spring flanges on the cage nuts are designed to lock into the holes.
Push in each of the thumbscrews on the front mounting brackets and turn the screws clockwise to secure the FastStor/support
4.
box assembly to the vertical mounting rails.
Install the AC line cord, SCSI cable and SCSI terminator to the rear of the FastStor by following the instructions in Chapter 2
5.
— Hardware Installation of the FastStor Installation and Operating Guide.
Use the cable ties to secure the AC line cord and SCSI cable to your rack. Be sure to leave enough slack in them to allow the
6.
FastStor to be pulled out of the rack on its rails as far as possible.
Your FastStor is now ready for use.
62-0125-01 FastStor Rack Mount Installation Instructions 13