Step 2: Installing The Stationary Sections Onto The Equipment Rack - Quantum LTO 2U Installation Manual

Step 2: Installing the Stationary Sections onto the Equipment
Rack
Figure 3 Sliding the
Intermediate Section
1 Slide the intermediate sections all the way back into the stationary
sections. If the intermediate section locks, push down on the green release
button to release. See
Green release
button
Intermediate
section
2 Loosely install the left and right stationary sections onto the equipment
rack using (8) M6 pan-head PHILLIPS screws. The ends of the stationary
sections go on outside of the equipment rack's upright rails. See
Note: The stationary sections are marked LEFT and RIGHT. Be sure
to install the sections on the correct sides.
3 Securely tighten the back bracket screws onto the equipment rack's
upright rails.
Note: Do not fully tighten the front bracket screws yet – you will do
this later.
Quantum 2U Rackmount Rail Installation Guide
figure 3.
Stationary
section
Document 81-81209-06 A01
January 2006
0
figure 4.
5