Step 2: Installing the Stationary Sections onto the Equipment
Rack
For 24-Inch Racks
Figure 3 Attaching the
Front of the Stationary
Section—Front View
Follow the instructions for your size rack as follows:
•
For 24-Inch Racks
•
For Racks Deeper than 24 Inches
0
1 Install both stationary sections onto the front pillars of the equipment
rack, using two screws in the bottom two mounting holes of each
stationary section (see
Configurations (For Reference Only)
appropriate mounting hardware.
Quantum 1U Rackmount Rail Installation Guide
on page 5
on page 7
figure
3). See
Typical Rack and Slide
on page 11 for information on
Document 81-81209-05 A01
January 2006
0
5