Attaching Two Faststor Units - Quantum FastStor 1 Install Manual

3. Using a #1 philips screwdriver, remove the two philips, panhead screws (#19) in the front and rear compartment of the
support box.
4. Using a #1 philips screwdriver, remove the philips, panhead screw (#8) and Kepnut (#9), in the front compartment of the
support box. You must open the front door of the FastStor and reach inside to hold the Kepnut (#9) while removing the
screw.
5. Using a #1 flat blade screwdriver, remove the two slotted, panhead screws (#3) that secure the slide (#15) to the right side of
the support box. You will be mounting the slide onto FastStor #2.
6. Remove the front mounting bracket (#16) from the right side of the support box by removing the two philips, panhead screws
(#7). You will be mounting the bracket on FastStor #2. Set the support box aside.

Attaching Two FastStor Units

1. Determine the model of FastStor #2 by performing the instructions detailed on page 6. Continue with these instructions when
FastStor #2 is ready for rack mounting.
2. Using a #1 philips screwdriver, remove the seven philips, panhead screws that secure the drive assembly to the rear of
FastStor #2 as shown in the following illustration.
CAUTION: Ensure that the AC power cord is disconnected from your FastStor before removing the drive assembly.
62-0125-01
9
19
16
4
3
2
1
FastStor Rack Mount Installation Instructions
19
8
15
7 x 2
3
5
6
7
3
9