Quantum FastStor 1 Install Manual page 14

11. Using a #1 philips screwdriver, install the right-hand mounting bracket (#16) to the right side of FastStor #2 using two
philips, panhead screws (#7). Be sure that the thumbscrews are positioned at the bottom.
12. If not already mounted, use a #1 philips screwdriver to install the left-hand mounting bracket (#16) to the left side of FastStor
#1 using two philips, panhead screws (#7). Be sure that the thumbscrews are positioned at the bottom.
13. Using a #1 flat blade screwdriver, secure the inner slide rail (#15) to the right side of FastStor # 2 by installing two slotted,
panhead screws (#3) as shown in the following illustration.
14. Replace the drive assembly in FastStor #2 using the seven philips screws removed earlier to secure the assembly to the rear.
15. Complete the rack mount installation of your dual FastStors by performing the steps detailed in the following section,
keeping in mind that the dual FastStors are equivalent to the FastStor/support box assembly referred to in the section.
12
16
FastStor Rack Mount Installation Instructions
4-40 Button Head Screw
(x 2 each side)
15
3
7
3
62-0125-01