Quantum FastStor 1 Install Manual page 7

Refer to the following illustration while performing Steps 3 and 4:
Typical Rack
Vertical
Mounting-Rail
Front of Rack
10 8 Places
Mount each slide rail assembly to your rack using four philips, panhead screws (#10) and a nut plate (#11) to secure them to
3.
the rack's vertical mounting-rails. Note that the rubber stop on the inner rail is positioned to the rear of the rack. Move the
rear outer rail-adapter (#14) on each assembly rearward as necessary to fit your rack, and then fully tighten the two screws
(#3) on the side of each rail.
If the rail assemblies are too short to fit your rack, fully tighten the two screws on the rear outer rail adapter. Now loosen the
4.
two screws that secure the front rail adapter to the assembly, and pull the front adapter away from the rail until the rail
assembly fits your rack. After mounting both slide rail assemblies, fully tightening all screws on the slide rail assemblies.
The next step in the process is to prepare the FastStor for rack mounting. If you are rack mounting a single FastStor unit, follow
the instructions in the next section, titled: Preparing a Single FastStor for Rack Mounting. If you are rack mounting dual FastStor
units, continue the installation procedure by going to the section titled Preparing Dual FastStors for Rack Mounting.
62-0125-01
Rubber Stop
FastStor Rack Mount Installation Instructions
14 Rear outer rail-adapter
3 8 places
6
4
11 4 Places
5