Chapter 2: Physical Specification
N
OTES
2.2.2
Mounting Holes (Side View)
Figure 4-1 shows the mounting holes and dimensions as viewed from the side of the tape drive.
Figure 2-2. Mounting Holes and Dimensions (Side View)
N
OTES
2-4
: 1 Tape drive width and length are standard 5¼-inch form factor
measurements.
2 Dimensions are identical on the left and right sides.
3 Length dimensions are from the front of the base plate.
: 1 Tape drive width and length are standard 5¼-inch form factor
measurements.
2 Dimensions are identical on the left and right sides.
3 Length dimensions are from the front of the base plate.
May 2004
001597-01 Rev. A09