Table 2-2. Electrical Requirements And Power Consumption; Table 2-3. Communication Interface And Mtbf - Quantum DLT VS80 Product Specification

Chapter 2: Physical Specification
Table 2-1. Physical Specifications (Continued)
Unit
Table 2-2 lists each tape drive unit's electrical requirements and power consumption.

Table 2-2. Electrical Requirements and Power Consumption

Unit
Internal
External
1
Voltage measured at the power bus connector pins.
2
Maximum current values are for approximately 300ms durations.
Table 2-3 shows the communication interface and MTBF for the DLT VS80 tape drive.

Table 2-3. Communication Interface and MTBF

Parameter
Communication Interface
MTBF
2-2
Parameter
Length
Weight
Shipping weight
Orientation
Parameter
1
+5 (+ 5%) Volt bus
1
+12 (+ 5%) Volt bus
Power Consumption
Power Requirements
Power Consumption
Value
Wide Ultra SCSI-2, Low-Voltage Differential (LVD)
200,000 hours at 100% Duty Cycle
Value
272.49 mm (10.728 in.)
3.48 kg (7.67 lbs)
5.21 kg (11.48 lbs) depending on configuration
Horizontal
Value
2
1.6 A Typical , 1.9 A Peak
2
0.65 A Typical , 3.5 A Peak
Less than 16W
100-240V (auto-ranging), 50/60 Hz, 0.9 A
Less than 35W
May 2004 001597-01 Rev. A09