Figure 9 Internal Tape Drive Mounting Locations - Front, Side, And Bottom Dimensions - Quantum SDLT 600 User Manual

Figure 9 Internal Tape Drive
Mounting Locations – Front, Side,
and Bottom Dimensions
SDLT 600 Product Manual
Configuring and Installing an Internal Tape Drive with SCSI Interface
Connecting the Internal Tape Drive Cables
This section discusses three connectors on the back of the internal SDLT
600 tape drive: 1) SCSI, 2) power, and 3) optional library/loader
connectors. Figure 10
used for the tabletop model.
SCSI and Power Connectors
orientation for the 68-pin SCSI connector and 4-pin power connector
located on the back of the internal tape drive.
The tables list pin assignments for the two possible SCSI connectors:
Multi-mode Single-Ended (MSE)/Single Ended (SE) mode in
Chapter 3 Installing Your Tape Drive
shows some typical AC power cord connectors
Figure 13 on page 60 shows the pin
table
3
3
27,
49