Figure 23 Detail Of The Empty Scsi Id Connector; Table 34 Scsi Id Address Selections - Quantum DLT S4 User Manual

Figure 23 Detail of the Empty
SCSI ID Connector
Table 34 SCSI ID Address
Selections
DLT-S4 Product Manual
For specific recommendations for assigning SCSI IDs, refer to
Note:
the system or SCSI controller documentation.
You can set the SCSI ID from 0 to 15. To change the SCSI ID, use your
fingers to place the supplied jumpers on the 12-pin SCSI ID jumper block
as follows:
• Figure 22 shows the location of the jumper block on the rear panel of
the tape drive.
• Figure 23 shows the empty 12-pin jumper block that you use to set
the SCSI ID.
• Table 34 shows how to place the jumpers to obtain the desired SCSI
ID.
SCSI ID
Jumper
Block
SCSI ID
Jumper
Block
SCSI ID
Jumper
Block
12
SCSI ID
Jumper
Block
Chapter 9 Installing an Internal SCSI Tape Drive
0 1
4
5 (default)
8 9
13
Setting the SCSI ID
3
2
6
7
10 11
14
15
70