Installing An Internal Scsi Tape Drive Equipment Required; Installation Steps - Quantum DLT S4 User Manual

Equipment Required

Installation Steps

DLT-S4 Product Manual
You need the following items to install the tape drive in a system:
• Four (4) M3 x 8 mm long screws
• Screwdriver
• Jumpers (supplied)
• Internal Ultra320 SCSI cable, SPI-4 (or SPI-5) compatible
• Active Ultra320 SCSI terminator (if the SCSI cable is already
terminated at the end then you do not need this item)
To install the tape drive, perform the following tasks in this order. Each
task is described in detail on the pages listed below.
Step No. Step
Unpack the tape drive.
1
Set the SCSI ID.
2
Secure the tape drive in the system.
3
Connect the cables and terminate the
4 SCSI bus.
Set TERMPWR.
5
Confirm the installation.
6
Add an additional device (optional).
7
Chapter 9 Installing an Internal SCSI Tape Drive
Equipment Required
9
9
Page
Page 69
Page 69
Page 71
Page 74
Page 77
Page 78
Page 78
67