Installing An Internal Sas Tape Drive Equipment Required; Installation Steps - Quantum DLT S4 User Manual

Equipment Required

Installation Steps

DLT-S4 Product Manual
You need the following items to install the tape drive in a system:
• Four (4) M3 x 8 mm long screws
• Screwdriver
• SAS cable
To install the tape drive, perform the following tasks in this order. Each
task is described in detail on the pages listed below.
Step No. Step
Unpack the tape drive.
1
Secure the tape drive in the system.
2
Connect the cables.
3
Confirm the installation.
4
Add additional devices (optional).
5
Chapter 11 Installing an Internal SAS Tape Drive
Equipment Required
11
11
Page
Page 92
Page 92
Page 95
Page 96
Page 97
90