Connecting The Cables - Quantum DLT S4 User Manual

Connecting the Cables

DLT-S4 Product Manual
Chapter 10 Installing an Internal Fibre Channel Tape Drive
Connect the Fibre Channel and power cables as follows:
Ensure that both the tape drive and computer are turned off.
1
Insert the fiber optic cable into the Fibre Channel port on the rear of
2
the tape drive (see
The connector is fully seated when it snaps into the port.
Insert the other end of the fiber optic cable into the Fibre Channel
3
port on the host computer.
If you are connecting several devices to the system,
Note:
connect only the tape drive to the host computer at this
time. Finish the installation procedure and confirm that
the host computer and tape drive are communicating
correctly before adding additional devices (see
Additional Devices
Locate an available DC power cable in the host computer and attach
4
it to the power connector on the rear panel of the tape drive (see
figure 33). The connector is keyed, preventing improper connection.
(See Power Connector Pin Assignments
number assignments and signal names.)
Check all cable connections to ensure that they are attached correctly,
5
seated firmly, and secured.
figure 33).
on page 88).
Connecting the Cables
Adding
on page 46 for power pin
10
86