Adding Additional Devices; Using The Loader/Library Interface Connector - Quantum DLT S4 User Manual

Adding Additional Devices

Using the Loader/Library Interface Connector

DLT-S4 Product Manual
Once you have successfully confirmed the installation of your tape drive,
you may add additional devices.
For each additional device:
Ensure that both the tape drive and host computer are turned off.
1
Insert the SAS cable into the SAS port on the device (for tape drives,
2
see figure 34).
Insert the other end of the SAS cable into the SAS port on the host
3
computer.
Check all cable connections and ensure that they are attached
4
correctly and seated firmly before turning the system on.
Confirm the installation (see
5
This connector is only used for tape drives installed in loaders/libraries.
If your system requires it to be used, it should have been pre-assembled
at the factory. For more information about the loader/library connector,
see Loader/Library Interface Connector
Chapter 11 Installing an Internal SAS Tape Drive
Confirming the Installation
on page 46.
Adding Additional Devices
on page 96).
11
11
97