Table of Contents
Advertisement
6.5.2 Port
Go to Config Network Port interface as shown below. HTTP port, Data port and RTSP port
can be set.
HTTP Port: The default HTTP port is 80. It can be changed to any port which is not occupied.
Data Port: The default data port is 9008. Please change it as required.
RTSP Port: The default port is 554. Please change it as required.
6.5.3 Server Configuration
This function is mainly used for connecting network video management system.
1.
Check "Enable".
2.
Check the IP address and port of the transfer media server in the ECMS/NVMS. Then
enable the auto report in the ECMS/NVMS when adding a new device. Next, input the
remaining information of the device in the ECMS/NVMS. After that, the system will
auto allot a device ID. Please check it in the ECMS/NVMS.
3.
Input the above-mentioned server address, server port and device ID in the
responding boxes. Click "Save" button to save the settings.
6.5.4 DDNS
If your camera is set to use PPPoE as its default network connection, DDNS should be set for
network access. Before you set the DDNS, please make sure you have registered a domain
name on the DDNS server.
1.
Go to Config Network DDNS.
28
Advertisement
Table of Contents
