Port Forwarding - Digital Watchdog MEGApix CaaS DWC-MB44Wi650C6 User Manual

Network Setup -

Port Forwarding

After entering the correct TCP/IP settings, you are
ready for 'Port Forwarding'(Cases A, B).
1. Please record the TCP/IP settings of your IP Camera for future
reference. You may need this information to access your IP
Camera and to configure 'Port Forwarding'.
IP Camera TCP/IP Settings
IP Address
Subnet Mask
Default Gateway
Preferred DNS Server
DDNS Server
Web Port
2. After clicking 'Apply', the system will prompt for reboot. Please
allow the system 50 seconds to reboot and accept the changes.
After 50 seconds, close the configuration screen. The view will
display 'Trying to Reconnect'. If the ACTIVE light on the IP
Camera has gone off and is now back on again flashing, the IP
Camera has rebooted. After the system reboots completely,
remove the power supply from the
unit and close Internet Explorer.
3. Return your PC/Laptop TCP/IP properties to their original
settings.
4. Before installing the IP Camera, you must use 'Port
Forwarding' on your personal router (Cases A, B).
You will need to forward 1 ports:
• Web Port
All the ports will be forwarded to the IP address you
assigned to the IP Camera.
In the example above, you would forward:
• 8888 192.168.0.200
For information on how to use 'Port Forwarding', please read
Appendix C.
20