Port; Server Configuration - Digital Watchdog MEGApix DWC-MVT4Wi28 User Manual

Trigger Email: when the IP address of the device is changed, the new IP address will
be sent to the email address that has been set up.
Trigger FTP: when the IP address of the device is changed, the new IP address will be
sent to FTP server that has been set up.

6.6.2 Port

Go to Config→Network→Port interface as shown below. HTTP port, Data port and
RTSP port can be set.
HTTP Port: The default HTTP port is 80. It can be changed to any port which is not
occupied.
HTTPS Port: The default HTTPs port is 443. It can be changed to any port which is not
occupied.
Data Port: The default data port is 9008. Please change it as necessary.
RTSP Port: The default port is 554. Please change it as necessary.

6.6.3 Server Configuration

This function is mainly used for connecting network video management system.
1. Check "Enable".
2. Check the IP address and port of the transfer media server in the ECMS/NVMS.
Then enable the auto report in the ECMS/NVMS when adding a new device. Next,
enter the remaining information of the device in the ECMS/NVMS. After that, the
system will automatically allot a device ID. Please check it in the ECMS/NVMS.
3. Enter the above-mentioned server address, server port and device ID in the
corresponding boxes. Click the "Save" button to save the settings.
37