Operating Procedures Using The Menu Mode; Exiting The Menu Mode - Quantum ACL 4/52 Operator's Manual

Chapter 2 Operating Procedures

Operating Procedures Using the Menu Mode

Entering the Menu
2
Mode

Exiting the Menu Mode

30
Operating Procedures Using the Menu
Mode
This section contains procedures for entering and exiting the control
panel menu mode and instructions for executing the operator tasks
listed below:
• Setting or changing the library or tape drive SCSI addresses
• Defining the state of the library after the power-up sequence has
completed
• Enabling or disabling the automatic drive cleaning option
• Enabling or disabling the retry operation option
• Setting or changing the language displayed in the SDA
• Adjusting the SDA contrast level
• Unloading a tape cartridge from a specific drive
• Directing cleaning tape cartridges to specific drives for cleaning
• Performing the initial loading of the library
• Displaying the status of the library
• Performing an inventory of the library
To enter the menu mode:
1 Press the control panel STANDBY button and verify the SDA
shows System Off-line .
2 Press the SELECT button to enter the menu mode.
3 Verify the following is displayed in the SDA:
M e n u :
C o n f i g u r a t i o n
2
There are two different ways to exit from menu mode.
The fast method:
1 From anywhere in the menu, press the SELECT and
buttons, simultaneously and verify that System Off-line is
displayed in the SDA.
ACL 4/52 Operator's Guide
2
or